Flotation feldspar concentrate — new raw material for producing components from electrical engineering porcelain. N. S. Demchenko 1, K. A. Kovalev 1, V. S. Romanovskii 1, V. I. Strel'nikov 1 & S. T. Frolov 1 Glass and Ceramics volume 47, pages 309–311 (1990)Cite this article
2016-4-14 Filtering and Drying of Feldspar Concentrate. The feldspar flotation concentrates are dewatered in a Classifier to approximately 20% moisture and further
2004-1-1 The amount of each collector was 300 g/t. The quality of feldspar concentrate measured by the total K 2 O + Na 2 O content was, in all three experiments, approximately the same (12.29%, 12.18% and 12.06% respectively). The content of Fe 2 O 3 in the feldspar concentrate obtained under these conditions in the flotation tests was 0.39%. As also
2016-11-1 Flotation experiments performed on a quartz-feldspar mixture demonstrate that quartz can be floated selectively from feldspars in diluted solutions of hydrofluoric acid (HF) simply by the aid of a frother. High grades and good recoveries were obtained for both quartz and feldspars. A feldspar concentrate of 99.9% at a recovery of 95.6% was
feldspar flotation concentrate stone crusher complete machine for sale Crusher Aggregate Equipment For Sale 2321 Listings Our engineers have designed a whole catalog of rock and stone crusher equipment capable of completing a wide range of medium to largesized applications Although most of our crushers and mills are constructed for heavyduty
2015-11-5 Direct Cationic Flotation of Feldspar Locally produced quaternary ammonium salt was used to separate the silica impurities from the previously ob-tained flotation concentrate. Hydrofluoric acid was added in this circuit as a silica depressant and a feldspar ac-tivator as well. Optimization of the process was carried out under the following
When the flotation products after ultrasonic pre-treatment were investigated, it was seen that the feldspar concentrate from the sample U1 contained 9.01% Na 2 O, 0.19% Fe 2 O 3, 0.15% TiO 2 and 0.47% MgO while the concentrate by conventional flotation
2015-9-10 present, the first flotation step may be bypassed. Sometimes the final flotation stage is omitted, leaving a feldspar-silica mixture (often referred to as sandspar), which is usually used in glassmaking. From the completed flotation process, the feldspar float concentrate is dewatered to 5 to 9 percent moisture.
2019-1-3 Flotation of this pulp was conducted in the usual manner. Results of these tests demonstrate that preconditioning the pulp below pH 3 and above pH 7 adversely affected feldspar recovery. In the range of pre-conditioning pH 3-7, recovery of feldspar and concentrate
2020-1-20 The concentrate of spodumene flotation (Test A) was analyzed by XRD indicating the existence of albite and quartz in the spodumene concentrate (Figure 12). Applying the Rietveld Refinement, it was possible to quantify the main minerals present in the concentrate: 59.7 % spodumene, 21.9 % albite and 18.4 % quartz.
Flotation feldspar concentrate — new raw material for producing components from electrical engineering porcelain. N. S. Demchenko 1, K. A. Kovalev 1, V. S. Romanovskii 1, V. I. Strel'nikov 1 & S. T. Frolov 1 Glass and Ceramics volume 47, pages 309–311 (1990)Cite this article
The K-feldspar flotation was performed in alkaline environment (pH 10.5–11.6) with only the addition of NaOH as a modifier and non-ionic Brij58 as a frother, on a fluorine-amine activated bulk
2015-9-10 present, the first flotation step may be bypassed. Sometimes the final flotation stage is omitted, leaving a feldspar-silica mixture (often referred to as sandspar), which is usually used in glassmaking. From the completed flotation process, the feldspar float concentrate is dewatered to 5 to 9 percent moisture.
The purpose of this research is to recover slime waste from feldspar flotation plant at Attanee International Co., Ltd., Tak province.Slime waste with particle size less than 230 mesh, is found
Feldspar ore is the main source of feldspar mineral concentrate or purified feldspar used in the manufacture of various grades of glass and ceramics including high-end ceramics and electronic-grade glass fibers. The glass and ceramic industries, in particular, are major consumers of feldspar, accounting for 95% of total consumption.
2013-4-23 2.4.1. Granite feldspar The froth flotation trials were successful in producing feldspar concentrates from the granite fines. The 600 to 106 J.1m concentrate contained at least 95% feldspar and 0.19% Fe203. The 300 to 106 J.1m concentrate also contained at least 95% feldspar and 0.26% Fe203. High-grade by-products were also produced.
2012-5-15 Abstract. In order to increase the quality of feldspar ore and to obtain sellable feldspar concentrate, it is necessary to remove coloring impurities such as iron and titanium contained in it. For the removal of coloring minerals from feldspar ore the most widely used method is reverse flotation method.
The mica concentrate was obtained by the flotation concentration, while feldspar and quartz were in the flotation underflow. According to the mineralogical analysis, the most abundant minerals are mica and chlorite/clays, while quartz and feldspar occur much less, and accessory minerals are represented in
The combined mineral processing process of " low intensity magnetic high intensity magnetic -flotation mica-feldspar quartz separation" was adopted. Columbite-tantalite concentrate was obtained with the Nb2O5 grade of 3241 g·t-1 and recovery of 54.32%, Ta2O5 grade of 1091 g·t-1and recovery of 45.45%.
2020-1-20 The concentrate of spodumene flotation (Test A) was analyzed by XRD indicating the existence of albite and quartz in the spodumene concentrate (Figure 12). Applying the Rietveld Refinement, it was possible to quantify the main minerals present in the concentrate: 59.7 % spodumene, 21.9 % albite and 18.4 % quartz.
2021-9-14 carried out at optimum conditions for flotation of feldspar minerals. The mass recovery of feldspar concentrate was 52.11% of feed -250+38 µm. On such optimum conditions, a suitable feldspar concentrate was obtained with 0.4% Fe 2 O 3 [Ahmed M. M., et al.,2016]. The component recovery of iron content removed into feldspar tailing was about 56%.
Feldspar ore is the main source of feldspar mineral concentrate or purified feldspar used in the manufacture of various grades of glass and ceramics including high-end ceramics and electronic-grade glass fibers. The glass and ceramic industries, in particular, are major consumers of feldspar, accounting for 95% of total consumption.
2019-6-25 Generally speaking, the feldspar concentrate rich in potassium and sodium is recovered by the combined mineral separation methods of gravity separation, electric separation, magnetic separation and flotation to remove associated minerals such as
In the experiment, TiO2+Fe2O3 in feldspar concentrate can be reduced to 0.12% or less under the conditions of appropriate collector dosage, grinding fineness and PH value. The process can be extended to industrial applications and feldspar concentrate meeting commercial requirements can be obtained. (4) scrub a flotation process
The Cationic Flotation of Feldspar When the feldspar pre-concentrate obtained under the predetermined optimum conditions was subjected to a differential cationic flotation process using the locally produced amine (0.25 kg/t) in presence of HF acid (1.3 kg/t), the optimum pH was found between 2.5
2009-8-26 Flotation of feldspar at a pH value of 2.4 Reduction of the iron content of the feldspar concentrate by magnetic separation. Results The flotation of mica and iron-bearing minerals was efficiently achieved with petroleum sulfonate collectors such as Aero 801 and 825, although the final feldspar concentrate
2016-4-1 onto mineral surfaces. The use of NaCl in flotation was found to increase the K-feldspar grade in the concentrate. This study clearly demonstrates that an effective separation of sodium feldspar from potassium feldspar from a weathered granite can be achieved by cationic flotation in HF medium using NaCl as a depressant. INTRODUCTION
The mica concentrate was obtained by the flotation concentration, while feldspar and quartz were in the flotation underflow. According to the mineralogical analysis, the most abundant minerals are mica and chlorite/clays, while quartz and feldspar occur much less, and accessory minerals are represented in
2020-1-20 The concentrate of spodumene flotation (Test A) was analyzed by XRD indicating the existence of albite and quartz in the spodumene concentrate (Figure 12). Applying the Rietveld Refinement, it was possible to quantify the main minerals present in the concentrate: 59.7 % spodumene, 21.9 % albite and 18.4 % quartz.
2009-8-27 1 Froth Flotation Fundamental Principles Froth flotation is a highly versatile method for physically separating particles based on differences in the ability of air bubbles to selectively adhere to specific mineral surfaces in a mineral/water slurry. The particles with attached air bubbles are then carried to the surface and